Zobrazenie zdroja stránky Serial LCD by Scott Edwards and Arduino

How to connect Scott Edwards's LCD Serial Backpack equipped LCD display to an Arduino compatible boards.



* [http://www.seetron.com/bpk000_1.htm LCD Serial Backpack] - product page
* [http://www.seetron.com/pdf/bpk_mnl.pdf LCD Serial Backpack manual] 
* [http://www.seetron.com/bpk_faq.htm LCD Serial Backpack FAQ]
* [http://www.seetron.com/lcd_andex.htm LCD Serial Backpack App Notes and Tips]

This serial LCD is not a direct connectible to the Arduino boards as it uses inverted signals (which is OK if You use e.g. RS-232 or Basic Stamp). 

'''Solutions:'''

a) use an hardware inverter. You can either use one section of an inverter IC, like a 7404, or a simple [http://www.seetron.com/images/invert.gif one-transistor inverter].

b) use an improved [http://arduiniana.org/libraries/newsoftserial/ NewSoftSerial library]. It enables to invert signals. Following diagram and program works like a charm.

[[Obrázok:ArduinoAndSESerialLCD.png|center]]

<source lang="c">
#include <NewSoftSerial.h>

#define rxPin 2          // unused, but necessary to create 'lcd' object
#define txPin 3

#define INVERTED true    // this is impossible with standard Software Serial library

NewSoftSerial lcd(rxPin, txPin,INVERTED);  // set up a new inverted serial port on pins 2 and 3

void setup() {

  pinMode(rxPin, INPUT);    // define pin modes for tx, rx:
  pinMode(txPin, OUTPUT);
  lcd.begin(9600);

  delay(100);               // necessary to wait after powering up

  lcd.print(254,BYTE);      // 254 is a command prefix
  lcd.print(1,BYTE);        // 1 is a Display Clear command
  delay(10);                // this command takes long time

  lcd.print(254,BYTE);      // for unknown reasons this is 
  lcd.print(1,BYTE);        // necessary to repeat 2x
  delay(10);

  lcd.print(254,BYTE);      // 254 is a command prefix
  lcd.print(2 ,BYTE);       // 2 is a Home command
  delay(10);

  lcd.print("Hello, World!");
}

void loop() {
  lcd.print(254,BYTE);
  lcd.print(192,BYTE);        // set the cursor to column 0, line 1

  lcd.print(millis()/1000);   // print the number of seconds since reset:

}

</source>