MEMS cvičenie 1: Rozdiel medzi revíziami

#define SerialSpeed 9600   //typical values are 9600 or 115200
#define SampFrequency 10   //sampling frequency in Hz (cycles per second)
#define positionSensor 5        //define your pin here
 
int mDelay;
int adcValue;
float outputValue;

void setup()
{
 Serial.begin(SerialSpeed);
 mDelay = 1000/SampFrequency; //calculate delay for proper sampling rate
}
 
void loop()
{
 adcValue = analogRead(positionSensor);
 /*  =============================================== */
 outputValue = adcValue;   // replace this line with your code 
 /*  =============================================== */
 Serial.print( outputValue ); //reads the analog port and prints value over serial
 Serial.print('\r');
 delay(mDelay); //delay in milliseconds

}